Skip to Navigation
Some alternators use an add-on type regulator that is mounted on the outside of the alternator housing.
A belt driven device that creates electrical current for maintaining the charge state of the battery and the electrical requirements for the vehicle
Commonly referred to as amps, this is an electrical unit of measure. Alternators are rated by the amp output capacity at a given voltage.
An electrical storage device used to supply electrical current for starting a vehicle.
A light in the vehicle instrument cluster that illuminates when the alternator is not charging or when there is a fault in the charging circuit.
This is the old unit being removed from the vehicle.
Diodes are used in pairs (positive and negative) to change the alternator output from alternating current (AC) to direct current (DC).
Direct Drive Starter
This type of starter has the drive gear attached to the armature or utilizes the armature as the drive gear.
External Fan (EF)
This alternator design has a fan mounted on the outside of the alternator that directs air flow across the internal components for cooling.
External Regulator (ER)
Some alternators use a voltage regulator that is not attached to the alternator. It is usually found on the fender well.
This is a large gear mounted to the back of the crankshaft which turns the engine when the starter is cranking.
Internal Fan (IF)
This alternator design has two fans built together with the rotor inside the alternator that directs air flow across the internal components for cooling.
Internal Regulator (IR)
Some alternators use a built-in type regulator that is mounted on the inside of the alternator housing.
Offset Gear Reduction Starter (OSGR)
This type of starter uses an internal gear set used to increase torque. The internal gear sets are offset which means the drive gear and motor rotate on different axes.
Permanent Magnet Starter
This type of starter uses magnets for magnetic poles rather than coils of wire (field coils). These units are lighter in weight and smaller in size.
Planetary Gear Reduction Starter (PGR)
This type of starter is similar to the Offset Gear Reduction, however the gear sets are not offset which means the drive gear and motor rotate on the same axis.
This is an electrical component in the alternator that contains sets of diodes which are used to change the alternator output from alternating current (AC) to direct current (DC).
This is an electrical switch on the starter that once energized allows the starter to engage the drive gear into the flywheel during starting.
This is an electrical motor that cranks the engine by moving a drive gear into the flywheel, thereby rotating the crankshaft.
This is the gear on the starter that engages the flywheel, causing the engine to crank.
This is an electrical component used to maintain the proper charge state of the battery by regulating alternator output.
Use our online catalog... Click Here
Use our dealer locator... Click Here